Calculator User Manual

Chapter 13: Tables 225
13TABLES.DOC TI-89/TI-92 Plus: Tables (English) Susan Gullord Revised: 02/23/01 1:08 PM Printed: 02/23/01 2:16 PM Page 225 of 10
To generate: tblStart
@
tbl Graph <
-
> Table Independent
A
n automatic table
¦ Based on
initial values
value value
OFF AUTO
¦ That matches
Graph screen
——
ON AUTO
A
manual table — — —
ASK
“—” means that any value entered for this parameter is ignored for
the indicated type of table.
In
SEQUENCE
graphing mode (Chapter 9), use integers for
tblStart
and
@
tbl
.
From the
TABLE SETUP
dialog box:
1. Use
D
and
C
to highlight the value or setting to change.
2. Specify the new value or setting.
To change: Do this:
tblStart
or
@
tbl
Type the new value. The existing value is
erased when you start to type.
— or —
Press
A
or
B
to remove the highlighting.
Then edit the existing value.
Graph <
-
> Table
or
Independent
Press
A
or
B
to display a menu of valid
settings. Then either:
¦ Move the cursor to highlight the
setting and press
¸
.
— or —
¦ Press the number for that setting.
3. After changing all applicable values or settings, press
¸
to
save your changes and close the dialog box.
You can set up a table’s parameters from the Home screen or a
program. You can:
¦ Store values directly to the system variables
tblStart
and
@
tbl
.
Refer to “Storing and Recalling Variable Values” in Chapter 2.
¦ Set
Graph <
-
> Table
and
Independent
by using the
setTable
function. Refer to Appendix A.
Which Setup
Parameters to Use
Changing the
Setup Parameters
Tip: To cancel a menu or
exit the dialog box without
saving any changes, press
N
instead of
¸
.
From the Home
Screen or a Program