Low Phase Noise Clock Evaluation Board User's Guide

www.ti.com
5 Installing the Software GUI and USB Driver
Installing the Software GUI and USB Driver
The CDCE421EVM software can be installed on a PC running the Microsoft Windows
®
2000 operating
system or higher (including Windows XP
®
).
To start software installation, run the ChronosSetup.msi file (available on the CD shipped with the EVM).
Figure 3 appears. Be sure to note the installation folder; the USB driver must be installed in the same after
setup completes and the USB cable is connected. See Figure 4 .
Figure 3. Software Installation Screen
Note the program file location; the USB controller driver is in the same location.
Figure 4. Installation Prompt
8 10.9MHz–1175MHz Low Phase Noise Clock Evaluation Board SCAU020 – March 2007
Submit Documentation Feedback