Computer Hardware User Manual

Connector J5
External power connector
Jumper J3 to ‘ext’
Jumper JP1
Open to measure current
Jumpers JP5 to JP10
Close 1-2 to debug in
Spy-Bi-Wire mode.
Close 2-3 to debug in
4-wire JTAG mode.
Jumper JP2
Open to disconnect LED
LED connected to P1.0
Jumper JP3
1-2 (int): Power supply via JTAG debug interface
2-3 (ext): External power supply
MSP-TS430PZ5x100 www.ti.com
Figure B-48. MSP-TS430PZ5x100 Target Socket Module, PCB
106
Hardware SLAU278F–May 2009–Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated