Computer Hardware User Manual

www.ti.com

MSP-TS430L092 Active Cable

Figure B-6 shows the PCB layout for the Active Cable. The following pinning is possible:

• JP1 has two jumpers (Jumper 1 and Jumper 2) that can be set as shown in Table B-3.

Table B-3. MSP-TS430L092 JP1 Settings

Jumper 1 Jumper 2 Description

Off Off The active cable has no power and does not function.

The active cable receives power from target socket. For this option, the

Off On

target socket must have its own power supply.

On Off The active cable receives power from the JTAG connector.

The JTAG connector powers the active cable and the target socket. For

On On this option, the target socket must not have its own power source, as this

would cause a not defined state.

• JP2 is for reset. For the standard MSP-TS430L092, this jumper must be set. It sets the reset pin to

high and can also control it. Without this jumper on the MSP-TS430L092, reset is set to zero.

Figure B-6. MSP-TS430L092 Active Cable Target Socket Module, PCB

SLAU278F–May 2009–Revised December 2010 Hardware

Submit Documentation Feedback