Datasheet

www.ti.com
FEATURES
1
2
3
4
8
7
6
5
R
RE
DE
D
V
CC
B
A
GND
SN65LVDM176D (Marked as DM176 or LVM176)
SN65LVDM176DGK (Marked as M76)
(TOP VIEW)
logic diagram (positive logic)
B
7
A
6
1
R
2
RE
3
DE
4
D
DESCRIPTION
SN65LVDM176
SLLS320D DECEMBER 1998 REVISED JULY 2000
HIGH-SPEED DIFFERENTIAL LINE TRANSCEIVER
Low-Voltage Differential Driver and Receiver
for Half-Duplex Operation
Designed for Signaling Rates of 400 Mbit/s
ESD Protection Exceeds 15 kV on Bus Pins
Operates From a Single 3.3-V Supply
Low-Voltage Differential Signaling With
Typical Output Voltages of 350 mV and a
50- Load
Valid Output With as Little as 50 mV Input
Voltage Difference
Propagation Delay Times
Driver: 1.7 ns Typ
Receiver: 3.7 ns Typ
Power Dissipation at 200 MHz
Driver: 50 mW Typical
Receiver: 60 mW Typical
LVTTL Levels Are 5-V Tolerant
Bus Pins Are High Impedance When Disabled
or With V
CC
Less Than 1.5 V
Open-Circuit Fail-Safe Receiver
Surface-Mount Packaging
D Package (SOIC)
DGK Package (MSOP)
The SN65LVDM176 is a differential line driver and receiver configured as a transceiver that uses low-voltage
differential signaling (LVDS) to achieve signaling rates as high as 400 Mbit/s. These circuits are similar to
TIA/EIA-644 standard compliant devices (SN65LVDS) counterparts except that the output current of the drivers is
doubled. This modification provides a minimum differential output voltage magnitude of 247 mV into a 50- load
and allows double-terminated lines and half-duplex operation. The receivers detect a voltage difference of less
than 50 mV with up to 1 V of ground potential difference between a transmitter and receiver.
The intended application of this device and signaling technique is for half-duplex or multiplex baseband data
transmission over controlled impedance media of approximately 100- characteristic impedance. The
transmission media may be printed-circuit board traces, backplanes, or cables. (Note: The ultimate rate and
distance of data transfer is dependent upon the attenuation characteristics of the media, the noise coupling to the
environment, and other application specific characteristics).
The SN65LVDM176 is characterized for operation from –40°C to 85°C.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Copyright © 1998–2000, Texas Instruments Incorporated
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.

Summary of content (23 pages)