Datasheet

ManualsBrandsTEXAS INSTRUMENTS ManualsInterface ICsInterface IC - drivers 2/0 PDIP 16

SN55113, SN75113

DUAL DIFFERENTIAL LINE DRIVERS

SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

D Choice of Open-Collector, Open-Emitter, or

3-State Outputs

D High-Impedance Output State for

Party-Line Applications

D Single-Ended or Differential AND/NAND

Outputs

D Single 5-V Supply

D Dual Channel Operation

D Compatible With TTL

D Short-Circuit Protection

D High-Current Outputs

D Common and Individual Output Controls

D Clamp Diodes at Inputs and Outputs

D Easily Adaptable to SN55114 and SN75114

Applications

D Designed for Use With SN55115 and

SN75115

description

The SN55113 and SN75113 dual differential line

drivers with 3-state outputs are designed to

provide all the features of the SN55114 and

SN75114 line drivers with the added feature of

driver output controls. Individual controls are

provided for each output pair, as well as a

common control for both output pairs. If any output

is low, the associated output is in a high-impedance state and the output can neither drive nor load the bus. This

permits many devices to be connected together on the same transmission line for party-line applications.

The output stages are similar to TTL totem-pole outputs, but with the sink outputs, YS and ZS, and the

corresponding active pullup terminals, YP and ZP, available on adjacent package pins.

The SN55113 is characterized for operation over the full military temperature range of −55°C to 125°C. The

SN75113 is characterized for operation over the temperature range of 0°C to 70°C.

PRODUCTION DATA information is current as of publication date.

Products conform to specifications per the terms of Texas Instruments

standard warranty. Production processing does not necessarily include

testing of all parameters.

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of

Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

1ZP

1ZS

1YS

1YP

GND

2ZP

2ZS

2YS

2YP

SN55113 ...J OR W PACKAGE

SN75113 ...N PACKAGE

(TOP VIEW)

3212019

910111213

2ZS

2YS

2YP

1YS

1YP

SN55113 . . . FK PACKAGE

(TOP VIEW)

1ZS

1ZP

2ZP

GND

NC − No internal connection

Summary of content (23 pages)

PAGE 1
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 D D D D D D D D D D D 3-State Outputs High-Impedance Output State for Party-Line Applications Single-Ended or Differential AND/NAND Outputs Single 5-V Supply Dual Channel Operation Compatible With TTL Short-Circuit Protection High-Current Outputs Common and Individual Output Controls Clamp Diodes at Inputs and Outputs Easily Adaptable to SN55114 and SN75114 Applications Designed for Use With SN55115 and SN75115
PAGE 2
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 FUNCTION TABLE OUTPUTS INPUTS DATA OUTPUT C CONTROL CC A B† AND Y NAND Z L X X X Z Z X L X X Z Z H H L X L H H H X L L H H H H H H L H = high level, L = low level, X = irrelevant, Z = high impedance (off) † B input and 4th line of function table are applicable only to driver number 1.
PAGE 3
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 schematic Input 1B Input 1A 5 6 16 V CC 1 kΩ 600 Ω † 4 kΩ V V † 600 Ω 9Ω 1 kΩ To Other Driver 600 Ω 4 kΩ 4 kΩ AND 4 Pullup 1YP ‡ 900 Ω 900 Ω † AND Sink 3 Output 1YS 100 Ω 333 Ω 90 Ω 5 kΩ 500 Ω V 4 kΩ Output 7 Control 1C 1.
PAGE 4
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 recommended operating conditions SN55113 Supply voltage, VCC High-level input voltage, VIH SN75113 MIN NOM MAX MIN NOM MAX 4.5 5 5.5 4.75 5 5.25 2 V 2 Low-level input voltage, VIL High-level output current, IOH Low-level output current, IOL Operating free-air temperature, TA UNIT −55 V 0.8 0.
PAGE 5
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 switching characteristics, VCC = 5 V, CL = 30 pF, TA = 25°C SN55113 PARAMETER TEST CONDITIONS MIN SN75113 TYP MAX 13 12 MIN UNIT TYP MAX 20 13 30 ns 20 12 30 ns tPLH Propagation delay time, low-to-high level output tPHL Propagation delay time, high-to-low-level output tPZH Output enable time to high level RL = 180 Ω, See Figure 2 7 15 7 20 ns tPZL Output enable time to low level R
PAGE 6
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 PARAMETER MEASUREMENT INFORMATION Input Pulse Generator (see Note A) 5V 50 Ω AND Output CL = 30 pF (see Note B) NAND Output CL = 30 pF (see Note B) 1 kΩ 5V TEST CIRCUIT ≤ 5 ns ≤ 5 ns Input 3V 90% 90% 1.5 V 1.5 V 10% 10% 0V tPZH VOH Output 1.5 V 0.5 V tPHZ Voff ≈ 0 V VOLTAGE WAVEFORMS NOTES: A. The pulse generator has the following characteristics: ZO = 50 Ω, PRR ≤ 500 kHz, tw = 100 ns. B.
PAGE 7
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 PARAMETER MEASUREMENT INFORMATION Input Pulse Generator (see Note A) 5V 50 Ω 5V 1 kΩ CL = 30 pF (see Note B) NAND Output AND Output RL 250 Ω Output CL = 30 pF (see Note B) TEST CIRCUIT ≤ 5 ns ≤ 5 ns 90% Input 1.5 V 3V 90% 1.5 V 10% 10% 0V tPZL tPLZ 5V Output 1.5 V 0.5 V VOL VOLTAGE WAVEFORMS NOTES: A. The pulse generator has the following characteristics: ZO = 50 Ω, PRR ≤ 500 kHz, tw = 100 ns.
PAGE 8
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 TYPICAL CHARACTERISTICS† OUTPUT VOLTAGE vs DATA INPUT VOLTAGE OUTPUT VOLTAGE vs DATA INPUT VOLTAGE ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ 6 6 VCC = 5 V No Load No Load TA = 25°C 5 ÁÁ ÁÁ ÁÁ VO VO − Output Voltage − V VO VO − Output Voltage − V 5 VCC = 5.5 V 4 VCC = 5 V VCC = 4.
PAGE 9
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 TYPICAL CHARACTERISTICS† OUTPUT VOLTAGE vs INPUT VOLTAGE (OUTPUT CONTROL) OUTPUT VOLTAGE vs INPUT VOLTAGE (OUTPUT CONTROL) VCC = 5.5 V VCC = 5 V 5 VO VO − Output Voltage − V VCC = 4.
PAGE 10
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 TYPICAL CHARACTERISTICS† SUPPLY CURRENT (BOTH DRIVERS) vs SUPPLY VOLTAGE LOW-LEVEL OUTPUT VOLTAGE vs OUTPUT CURRENT TA = 25°C No Load TA = 25°C 70 ICC ICC − Supply Current − mA 0.5 VOL VOL − Output Voltage − V ÁÁÁÁ ÁÁÁÁ 80 0.6 VCC = 4.5 V 0.4 0.3 VCC = 5.5 V ÁÁÁ ÁÁÁ 60 Inputs Grounded 50 Inputs Open 40 ÁÁ ÁÁ 0.2 0.
PAGE 11
SN55113, SN75113 DUAL DIFFERENTIAL LINE DRIVERS SLLS070C − SEPTEMBER 1973 − REVISED MARCH 1997 TYPICAL CHARACTERISTICS† OUTPUT ENABLE AND DISABLE TIMES vs FREE-AIR TEMPERATURE ÁÁÁÁÁ ÁÁÁÁÁ ÁÁÁÁÁ 20 18 30 VCC = 5 V CL = 30 pF See Figure 1 Output Enable and Disable Times − ns Propagation Delay Times From Data Inputs − ns PROPAGATION DELAY TIMES FROM DATA INPUTS vs FREE-AIR TEMPERATURE 16 tPLH 14 12 tPHL 10 8 6 4 2 0 − 75 − 50 − 25 0 25 50 75 100 ÁÁÁÁÁÁ ÁÁÁÁÁÁ VCC = 5 V See Figures 2 and 3
PAGE 12
PACKAGE OPTION ADDENDUM www.ti.
PAGE 13
PACKAGE OPTION ADDENDUM www.ti.com 25-Sep-2013 (1) The marketing status values are defined as follows: ACTIVE: Product device recommended for new designs. LIFEBUY: TI has announced that the device will be discontinued, and a lifetime-buy period is in effect. NRND: Not recommended for new designs. Device is in production to support existing customers, but TI does not recommend using this part in a new design. PREVIEW: Device has been announced but is not in production.
PAGE 14
PACKAGE OPTION ADDENDUM www.ti.
PAGE 15
PACKAGE MATERIALS INFORMATION www.ti.com 14-Jul-2012 TAPE AND REEL INFORMATION *All dimensions are nominal Device SN75113NSR Package Package Pins Type Drawing SO NS 16 SPQ Reel Reel A0 Diameter Width (mm) (mm) W1 (mm) 2000 330.0 16.4 Pack Materials-Page 1 8.2 B0 (mm) K0 (mm) P1 (mm) W Pin1 (mm) Quadrant 10.5 2.5 12.0 16.
PAGE 16
PACKAGE MATERIALS INFORMATION www.ti.com 14-Jul-2012 *All dimensions are nominal Device Package Type Package Drawing Pins SPQ Length (mm) Width (mm) Height (mm) SN75113NSR SO NS 16 2000 367.0 367.0 38.
PAGE 17
PAGE 18
PAGE 19
PAGE 20
PAGE 21
PAGE 22
PAGE 23
IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue. Buyers should obtain the latest relevant information before placing orders and should verify that such information is current and complete.