VLYNQ Port User's Guide

www.ti.com
3.13 Receive Address Map Size 3 Register (RAMS3)
3.14 Receive Address Map Offset 3 Register (RAMO3)
VLYNQ Port Registers
The receive address map size 3 register (RAMS3) is used to identify the intended destination of inbound
serial packets. The RAMS3 is shown in Figure 21 and described in Table 18 .
Figure 21. Receive Address Map Size 3 Register (RAMS3)
31 2 1 0
RXADRSIZE3 Reserved
R/W-0 R-0
LEGEND: R/W = Read/Write; R = Read only; - n = value after reset
Table 18. Receive Address Map Size 3 Register (RAMS3) Field Descriptions
Bit Field Value Description
31-2 RXADRSIZE3 0-3FFF FFFFh The RXADRSIZE3 field is used to determine if receive packets are destined for the third of
four mapped address regions. RXADRSIZE3 is compared with the address contained in the
receive packet. If the receive packet address is less than the value in RXADRSIZE3, the
packet address is added to the receive address map offset 3 register (RAMO3) to obtain the
translated address.
1-0 Reserved 0 Reserved. Always read as 0. Writes have no effect.
The receive address map offset 3 register (RAMO3) is used with the receive address map size 3 register
(RAMS3) to translate receive packet addresses to local device configuration bus addresses. The RAMO3
is shown in Figure 22 and described in Table 19 .
Figure 22. Receive Address Map Offset 3 Register (RAMO3)
31 2 1 0
RXADROFFSET3 Reserved
R/W-0 R-0
LEGEND: R/W = Read/Write; R = Read only; - n = value after reset
Table 19. Receive Address Map Offset 3 Register (RAMO3) Field Descriptions
Bit Field Value Description
31-2 RXADROFFSET3 0-3FFF FFFFh The RXADROFFSET3 field is used with the receive address map size 3 register (RAMS3)
to determine the translated address for serial data. If the receive packet address is less
than the value in RAMS3, the packet address is added to the contents of this register to
obtain the translated address.
1-0 Reserved 0 Reserved. Always read as 0. Writes have no effect.
SPRU938B September 2007 VLYNQ Port 35
Submit Documentation Feedback