User Manual

Statistics 12-11
8312STAT.DOC TI-83 international English Bob Fedorisko Revised: 02/19/01 12:42 PM Printed: 02/19/01 1:37
PM Page 11 of 38
To enter a list name in the stat list editor, follow these steps.
1. Display the
Name= prompt in the entry line in either of
two ways.
•
Move the cursor onto the list name in the column
where you want to insert a list, and then press
y
[
INS
]. An unnamed column is displayed and the
remaining lists shift right one column.
•
Press
}
until the cursor is on the top line, and then
press
~
until you reach the unnamed column.
Note:
If list names are stored to all 20 columns, you must remove
a list name to make room for an unnamed column.
The Name= prompt is displayed and alpha-lock is on.
2. Enter a valid list name in any of four ways.
•
Select a name from the
LIST NAMES
menu (Chapter 11).
•
Enter
L
1
, L
2
, L
3
, L
4
, L
5
, or L
6
from the keyboard.
•
Enter an existing user-created list name directly from
the keyboard.
•
Enter a new user-created list name (page 12
.
12).
3. Press
Í
or
†
to store the list name and its
elements, if any, in the current column of the stat list
editor.
To begin entering, scrolling, or editing list elements, press
†
. The rectangular cursor is displayed.
Note:
If the list name you entered in step 2 already was stored in
another stat list editor column, then the list and its elements, if any,
move to the current column from the previous column. Remaining list
names shift accordingly.
Using the Stat List Editor
Entering a List
Name in the Stat
List Editor