Application Guide

Collecting Data
Collecting Time-Based Data
The Time Based collection mode captures sensor data automatically at regular time
intervals.
1. Connect the sensor or sensors.
Sensor names are added to the sensor list automatically.
2. From the Experiment menu, select New Experiment.
This removes all data and restores all meter settings to their defaults.
3. From the Experiment menu, select Collection Mode > Time Based.
a) Select Rate or Interval from the drop-down list, and then type the Rate
(samples/second) or Interval (seconds/sample).
b) Type the Duration of the collection.
The Number of points is calculated and displayed, based on rate and duration.
Note that collecting too many data points can slow system performance.
c) Select Strip Chart if you want to collect samples continuously, retaining only the
last n samples. (where “n” is the number shown in the Number of points field.)
4. Modify sensor settings as necessary.
5. Click Start Collection .
6. After the data has been collected, click Stop Collection .
The data set run is complete.
Collecting Selected Events
Use the Selected Events collection mode to capture samples manually. In this mode,
each sample is automatically assigned an event number.
1. Connect the sensor or sensors.
Data Collection 427