Datasheet

TLV320AIC3105
SLAS513B – FEBRUARY 2007 – REVISED DECEMBER 2008 ......................................................................................................................................... www.ti.com
Page 0/Register 65: HPROUT Output Level Control Register
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 – D4 R/W 0000 HPROUT Output Level Control
0000: Output level control = 0 dB
0001: Output level control = 1 dB
0010: Output level control = 2 dB
...
1000: Output level control = 8 dB
1001: Output level control = 9 dB
1010 – 1111: Reserved. Do not write these sequences to these register bits.
D3 R/W 0 HPROUT Mute
0: HPROUT is muted
1: HPROUT is not muted
D2 R/W 1 HPROUT Power-Down Drive Control
0: HPROUT is weakly driven to a common mode when powered down.
1: HPROUT is high-impedance when powered down.
D1 R 1 HPROUT Volume Control Status
0: All programmed gains to HPROUT have been applied
1: Not all programmed gains to HPROUT have been applied yet
D0 R/W 0 HPROUT Power Control
0: HPROUT is not fully powered up.
1: HPROUT is fully powered up.
Page 0/Register 66: LINE2L to HPRCOM Volume Control Register
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 R/W 0 LINE2L Output Routing Control
0: LINE2L is not routed to HPRCOM
1: LINE2L is routed to HPRCOM
D6 – D0 R/W 000 0000 LINE2L to HPRCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 6
Page 0/Register 67: PGA_L to HPRCOM Volume Control Register
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 R/W 0 PGA_L Output Routing Control
0: PGA_L is not routed to HPRCOM
1: PGA_L is routed to HPRCOM
D6 – D0 R/W 000 0000 PGA_L to HPRCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 6
Page 0/Register 68: DAC_L1 to HPRCOM Volume Control Register
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 R/W 0 DAC_L1 Output Routing Control
0: DAC_L1 is not routed to HPRCOM.
1: DAC_L1 is routed to HPRCOM.
D6 – D0 R/W 000 0000 DAC_L1 to HPRCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 6
Page 0/Register 69: LINE2R to HPRCOM Volume Control Register
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 R/W 0 LINE2R Output Routing Control
0: LINE2R is not routed to HPRCOM
1: LINE2R is routed to HPRCOM
D6 – D0 R/W 000 0000 LINE2R to HPRCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 6
70 Submit Documentation Feedback Copyright © 2007 – 2008, Texas Instruments Incorporated
Product Folder Link(s): TLV320AIC3105