Datasheet
TLV320AIC3105
SLAS513B – FEBRUARY 2007 – REVISED DECEMBER 2008 .........................................................................................................................................
www.ti.com
Page 0/Register 96: Sticky Interrupt Flags Register
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 R 0 HPLOUT Short-Circuit Detection Status
0: No short circuit detected at HPLOUT driver
1: Short circuit detected at HPLOUT driver
D6 R 0 HPROUT Short-Circuit Detection Status
0: No short circuit detected at HPROUT driver
1: Short circuit detected at HPROUT driver
D5 R 0 HPLCOM Short-Circuit Detection Status
0: No short circuit detected at HPLCOM driver
1: Short circuit detected at HPLCOM driver
D4 R 0 HPRCOM Short-Circuit Detection Status
0: No short circuit detected at HPRCOM driver
1: Short circuit detected at HPRCOM driver
D3 R 0 Reserved. Do not write to this bit.
D2 R 0 Headset Detection Status
0: No headset insertion/removal is detected.
1: Headset insertion/removal is detected.
D1 R 0 Left ADC AGC Noise Gate Status
0: Left ADC signal power is greater than or equal to noise threshold for left AGC.
1: Left ADC signal power is less than noise threshold for left AGC.
D0 R 0 Right ADC AGC Noise Gate Status
0: Right ADC signal power is greater than or equal to noise threshold for right AGC.
1: Right ADC signal power is less than noise threshold for right AGC.
Page 0/Register 97: Real-Time Interrupt Flags Register
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 R 0 HPLOUT Short-Circuit Detection Status
0: No short circuit detected at HPLOUT driver
1: Short circuit detected at HPLOUT driver
D6 R 0 HPROUT Short-Circuit Detection Status
0: No short circuit detected at HPROUT driver
1: Short circuit detected at HPROUT driver
D5 R 0 HPLCOM Short-Circuit Detection Status
0: No short circuit detected at HPLCOM driver
1: Short circuit detected at HPLCOM driver
D4 R 0 HPRCOM Short-Circuit Detection Status
0: No short circuit detected at HPRCOM driver
1: Short circuit detected at HPRCOM driver
D3 R 0 Reserved. Do not write to this bit.
D2 R 0 Headset Detection Status
0: No headset insertion/removal is detected.
1: Headset insertion/removal is detected.
D1 R 0 Left ADC AGC Noise Gate Status
0: Left ADC signal power is greater than noise threshold for left AGC.
1: Left ADC signal power lower than noise threshold for left AGC.
D0 R 0 Right ADC AGC Noise Gate Status
0: Right ADC signal power is greater than noise threshold for right AGC.
1: Right ADC signal power is lower than noise threshold for right AGC.
Page 0/Register 98 – 100: Reserved Registers
BIT READ/ RESET DESCRIPTION
WRITE VALUE
D7 – D0 R 0000 0000 Reserved. Do not write to these registers.
76 Submit Documentation Feedback Copyright © 2007 – 2008, Texas Instruments Incorporated
Product Folder Link(s): TLV320AIC3105