Computer Hardware User Manual

www.ti.com Using the DDR2 Memory Controller
Table 15. SDTIM2 Configuration
DDR2 SDRAM Data
Register Field Sheet Parameter Data Sheet Formula (Register Field
Name Name Description Value Field Must Be ≥) Value
T_ODT t
AOND
t
AOND
specifies the ODT turn-on 2 (t
CK
cycles) t
AOND
2
delay
T_XSNR t
XSNR
Exit self refresh to a non-read 137.5 ns (t
XSNR
× f
DDR2_CLK
) - 1 34
command
T_XSRD t
XSRD
Exit self refresh to a read 200 (t
CK
cycles) (t
XSRD
) - 1 199
command
T_RTP t
RTP
Read to precharge command 7.5 ns (t
RTP
× f
DDR2_CLK
) - 1 1
delay
T_CKE t
CKE
CKE minimum pulse width 3 (t
CK
cycles) (t
CKE
) - 1 2
3.2.4 Configuring the DDR2 Memory Controller Control Register (DMCCTL)
The DDR2 memory controller control register (DMCCTL) contains a read latency (RL) field that helps the
DDR2 memory controller determine when to sample read data. The RL field should be programmed to a
value equal to CAS latency + 1. For example, if a CAS latency of 4 is used, then RL should be
programmed to 5.
Table 16. DMCCTL Configuration
Register
Register Field Name Description Value
IFRESET Programmed to be out of reset. 0
RL Read latency is equal to CAS latency + 1. 5
37
SPRU970G– December 2005– Revised June 2011 C6455/C6454 DDR2 Memory Controller
Submit Documentation Feedback
Copyright © 2005–2011, Texas Instruments Incorporated