Incor User's Guide Ethernet Media Access Controller TMS320C645x DSP

www.ti.com
4.6 MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
MDIO Registers
The MDIO link status change interrupt (unmasked) register (LINKINTRAW) is shown in Figure 20 and
described in Table 19 .
Figure 20. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
31 16
Reserved
R-0
15 2 1 0
Reserved LINKINTRAW
R-0 R/WC-0
LEGEND: R = Read only; R/WC = Read/Write 1 to clear; - n = value after reset
Table 19. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW) Field
Descriptions
Bit Field Value Description
31-2 Reserved 0 Reserved
1-0 LINKINTRAW MDIO Link change event, raw value. When asserted, a bit indicates that there was an MDIO link
change event (i.e. change in the LINK register) corresponding to the PHY address in the
USERPHYSEL register. LINKINTRAW[0] and LINKINTRAW[1] correspond to USERPHYSEL0 and
USERPHYSEL1, respectively. Writing a 1 will clear the event and writing 0 has no effect.
SPRU975B – August 2006 Ethernet Media Access Controller (EMAC)/Management Data Input/Output (MDIO) 71
Submit Documentation Feedback