Stereo System User Manual

www.ti.com
EM_D[31:16]/UHPI_HA[15:0]
(A)
UHPI_HCNTL[1:0]
UHPI_HD[15:0]
UHPI_HD[16]/HHWIL
UHPI_HD[31:17]
UHPI_HAS
(B)
UHPI_HBE[3:0]
UHPI_HRW
UHPI_HDS[2]
UHPI_HDS[1]
UHPI_HCS
UHPI_HRDY
AMUTE2/HINT
NC
A[x:y]
(C)
D[15:0]
D[16]
BE[3:0
]
(D)
R/W
WE
(E)
RD
(E)
CS
RDY
INTERRUPT
DSP External Host MCU
D[31:17]
TMS320C6727, TMS320C6726, TMS320C6722
Floating-Point Digital Signal Processors
SPRS268E – MAY 2005 – REVISED JANUARY 2007
Figure 4-16 illustrates the Multiplexed Host Address/Data Fullword Mode hookup between the C672x DSP
and an external host microcontroller. In this mode, all 32 bits of UHPI_HD[31:0] are used and the host can
access HPIA, HPID, and HPIC in a single bus cycle.
A. May be used as EM_D[31:16]
B. Optional for hosts supporting multiplexed address and data. Pull up if not used. Low when address is on the bus.
C. Two host address lines or host GPIO if address lines are not available.
D. Byte Enables (active during reads and writes). Some processors support a byte-enable mode on their write enable
pins.
E. Only required if needed for strobe timing. Not required if CS meets strobe timing requirements.
Figure 4-16. UHPI Multiplexed Host Address/Data Fullword Mode
Submit Documentation Feedback Peripheral and Electrical Specifications 57