Serial RapidIO (SRIO) User's Guide

www.ti.com
5.39 LSU n Control Register 6 (LSU n_REG6)
SRIO Registers
There are four of these registers, one for each LSU (see Table 99 ). LSU n_REG6 is shown in Figure 100
and described in Table 100 . For additional programming see Section 2.3.3 .
Table 99. LSU n_REG6 Registers and the Associated LSUs
Register Address Offset Associated LSU
LSU1_REG6 0418h LSU1
LSU2_REG6 0438h LSU2
LSU3_REG6 0458h LSU3
LSU4_REG6 0478h LSU4
Figure 100. LSU n Control Register 6 (LSU n_REG6)
31 16
Reserved
R-0000h
15 5 4 1 0
Reserved COMPLETION_CODE BSY
R-000h R-0000 R-0
LEGEND: R = Read only; - n = Value after reset
Table 100. LSU n Control Register 6 (LSU n_REG6) Field Descriptions
Bit Field Value Description
31–5 Reserved 0000h These read-only bits return 0s when read.
4–1 COMPLETION_CODE Indicates the status of the pending command.
0000b Transaction complete, no errors (posted/non-posted)
0001b Transaction timeout occurred on non-posted transaction
0010 b Transaction complete, packet not sent due to flow control blockade (Xoff)
0011b Transaction complete, non-posted response packet (type 8 and 13)
contained ERROR status, or response payload length was in error
0100b Transaction complete, packet not sent due to unsupported transaction type or
invalid programming encoding for one or more LSU register fields
0101b DMA data transfer error
0110b "Retry" DOORBELL response received, or Atomic test-and-swap was not
allowed (semaphore in use)
0111b Transaction complete, packet not sent due to unavailable outbound credit at
given priority
1xxxb Reserved
0 BSY Indicates status of the writeable LSU registers
0 LSU registers available (writable) for next set of transfer descriptors
1 LSU registers busy with current transfer
SPRUE13A – September 2006 Serial RapidIO (SRIO) 161
Submit Documentation Feedback