- TMS370 Microcontroller/Gang Programmer User's Guide

Configuration Window Overview and Description
2-5
2.5 Configuration Window Overview and Description
If you use the configuration command while in the display window, the config-
uration window illustrated in Figure 2–2 is displayed; it also displays when
the programmer software is first invoked.
Figure 2–2. Configuration Window at System Startup
Show D ddDevice dit oad hooseDevice ave isplay ui
t
CONFIG:
AEL DQC SI
Program Configuration
Port#: 1
Device Type
27128 TMS27C128
27256 TMS27C256
2732 TMS2732A
2764 TMS2764
TMS27C64
7742 TMS7742
TMS370 16K_PE
256_DEE
4K_PEE
512_DEE
C010
C050
The configuration window consists of three different areas—a command line,
a program configuration area, and the device table.
The
command line lists the available commands you can use to manipulate
the data in the configuration window. These commands are listed in Table 2–2
and described in detail in Sections 2.7 through 2.14.
Table 2–2. Configuration Window Commands
Command Function
Show ID Display software title and revision level.
Add Device Add a new device to the device table.
Edit Edit the configuration parameters.
Load File Load current configuration or current device table from a file.
Choose Device Choose (set) the current device type.
Save File Save the current configuration or the current device table in a file.
Display Go to the display window.
Quit Quit (exit) and return to DOS.
The program configuration area lists the current selection of the communica-
tion port—port 1 or 2. To change this value, refer to Section 2.9.