Network Router User Manual

TMS380C26
NETWORK COMMPROCESSOR
SPWS010A–APRIL 1992–REVISED MARCH 1993
POST OFFICE BOX 1443 • HOUSTON, TEXAS
77251–1443
65
PARAMETER MEASUREMENT INFORMATION
80x8x interrupt acknowledge timing – first SIACK
pulse
NO. PARAMETER MIN MAX UNIT
286 Pulse duration, SIACK high between DIO accesses (see Note 21) 55 ns
287 Pulse duration, SIACK low on first pulse of two pulses 62.5 ns
NOTE 21: The “inactive” chip select is SIACK in DIO read and DIO write cycles, and SCS is the “inactive” chip select in interrupt acknowledge
cycles.
SIACK
SRD, SWR,
SCS
First
286
287
Second
Figure 30. 80x8x Interrupt Acknowledge Timing – First SIACK Pulse
80x8x interrupt acknowledge timing – second SIACK pulse
NO. PARAMETER MIN MAX UNIT
255 Delay from SRDY low to SCS high 15 ns
259
†
Hold of SAD high-impedance after SIACK low (see Note 21) 0 ns
260 Setup of output data valid before SRDY low 0 ns
261
†
Delay from SIACK high to SAD high-impedance (see Note 21) 35 ns
261a Hold of output data valid after SIACK high (see Note 21) 0 ns
272a Setup of inactive data strobe high to SIACK no longer high 55 ns
273a Hold of inactive data strobe high after SIACK high 55 ns
275 Delay from SIACK high to SRDY high (see Note 21) 35 ns
276
‡
Delay from SRDY low in the first DIO access to the SIF register to SRDY low in the immediately
following access to the SIF
4000 ns
279
†
Delay from SIACK high to SRDY high impedance 65 ns
282a Delay from SDBEN low to SRDY low in a read cycle 35 ns
282R
Delay from SIACK low to SDBEN low (see TMS380 Second Generation Token-Ring
User’s Guide,
SPWU005, subsection 3.4.1.1.1), provided previous cycle completed
55 ns
283R Delay from SIACK high to SDBEN high (see Note 21) 35 ns
†
This specification is provided as an aid to board design.
‡
This specification has been characterized to meet stated value.
NOTE 21: The “inactive” chip select is SIACK
in DIO read and DIO write cycles, and SCS is the “inactive” chip select in interrupt acknowledge
cycles.