User Manual

ManualsBrandsTexas Instruments ManualsElectronicsRadio Frequency Identification (RFID)

3DESREADER DEMO Ver. 1.0

TI Proprietary Information 1 5/20/02

Reader Terminal POS Emulator Installation Instructions:

Caution: Any modification or changes to the unit not expressively authorized by the

party responsible for compliance may void the users authority to operate the

equipment.

1. Installation of POS Emulation S/W Program: 3DESREADER POS DEMO 1.0

a. Install CD into drive.

b. From file manager/explorer select file STARTUP.EXE.

c. Walk through standard installation process by following prompts.

d. Installation is now complete.

2. Installation of Reader Terminal (Refer to Fig 1)

a. Plug the RJ-45 side of the RS-232 (via RJ-45) Serial cable into the left-most

socket of the reader & the DB-9 side of the cable into one of the COM ports of

your PC (Typically COM 2 port).

c. Plug the Power input (RJ-45) into the right-most socket (Red Socket).

Figure 1

3. Starting the 3DESREADER DEMO 1.0 Program

a. Select the Windows START button and select PROGRAMS from the drop down

menu.

b. From PROGRAMS select 3DESREADER DEMO 1.0

c. The program will now launch and you will see the screen noted in figure 2.

RS-232

input via

RJ-45

Power Input

(Red Socket)

RS-485

input via

RJ-45

Summary of content (6 pages)

PAGE 1
3DESREADER DEMO Ver. 1.0 Reader Terminal POS Emulator Installation Instructions: Caution: Any modification or changes to the unit not expressively authorized by the party responsible for compliance may void the users authority to operate the equipment. 1. Installation of POS Emulation S/W Program: 3DESREADER POS DEMO 1.0 a. b. c. d. Install CD into drive. From file manager/explorer select file STARTUP.EXE. Walk through standard installation process by following prompts. Installation is now complete. 2.
PAGE 2
3DESREADER DEMO Ver. 1.0 Figure 2. 4. Select the CONNECT READER button. If properly connected the screen then should appear as that in figure 3. Figure 3. 5. Press the PROCESS button and then present the token to the reader antenna. The reader will then look for the token and the screen will then appear as that noted in figure 4 (“Looking for Token”). Once the token is found the screen will then shift to that as noted in figure 5.
PAGE 3
DESREADER DEMO Ver. 1.
PAGE 4
3DESREADER DEMO Ver. 1.0 6. To simulate the Payment Authorization Process, select the OK button (Figure 5) at which point the program will simulate the authorization process while displaying the correct lighting sequence. 7. The Find Token command (Figure 6) can be used just to identify a token that has been placed within the antennas read field. Figure 6: Find Token Command 8. To manually turn the LED’s on you can select the Turn LED On button on the main menu Figure 7. Figure 7.
PAGE 5
3DESREADER DEMO Ver. 1.0 9. To manually turn the LED’s off select the Turn LED Off button as noted in figure 8. Figure 8 10. To disconnect the reader terminal select the command Disconnect from the main menu Figure 9. Figure 9. 11. To test the second antenna, unplug the existing antenna as well as the power. Then plug in the second antenna and then reapply the power connection. You can then use the program as noted in the aforementioned sections.
PAGE 6
3DESREADER DEMO Ver. 1.