Datasheet

TVP5160
SLES135E–FEBRUARY 2005–REVISED APRIL 2011 www.ti.com
Table 3-83. AGC White Peak Processing
Subaddress 74h
Default 00h
7 6 5 4 3 2 1 0
Luma peak A Reserved Color burst A Sync height A Luma peak B Composite Color burst B Sync height B
peak
Luma peak A: Use of the luma peak as a video amplitude reference for the back-end feed-forward type AGC algorithm
0 = Enabled (default)
1 = Disabled
Color burst A: Use of the color burst amplitude as a video amplitude reference for the back-end
NOTE: Not available for SECAM, component and B/W video sources.
0 = Enabled (default)
1 = Disabled
Sync height A: Use of the sync height as a video amplitude reference for the back-end feed-forward type AGC algorithm
0 = Enabled (default)
1 = Disabled
Luma peak B: Use of the luma peak as a video amplitude reference for front-end feedback type AGC algorithm
0 = Enabled (default)
1 = Disabled
Composite peak: Use of the composite peak as a video amplitude reference for front-end feedback type AGC algorithm
NOTE: Required for CVBS video sources
0 = Enabled (default)
1 = Disabled
Color burst B: Use of the color burst amplitude as a video amplitude reference for front-end feedback type AGC algorithm
NOTE: Not available for SECAM, component and B/W video sources
0 = Enabled (default)
1 = Disabled
Sync height B: Use of the sync-height as a video amplitude reference for front-end feedback type AGC algorithm
0 = Enabled (default)
1 = Disabled
NOTE: If all 4 bits of the lower nibble are set to 1111b (that is, no amplitude reference selected), then the front-end analog and digital
gains are automatically set to nominal values.
If all 4 bits of the upper nibble are set to 1111b (that is, no amplitude reference selected), then the back-end gain is set automatically to
unity. If the input sync height is greater than 100% and the AGC-adjusted output video amplitude becomes less than 100%, then the
back-end scale factor attempts to increase the contrast in the back-end to restore the video amplitude to 100%.
Table 3-84. F-Bit and V-Bit Control
Subaddress 75h
Default 16h
7 6 5 4 3 2 1 0
Reserved 1 F and V [1:0] 1 Reserved
F and V [1:0]
F AND V
(1)
LINES PER FRAME F BIT V BIT
Standard ITU-R BT 656 ITU-R BT.656
00 = Nonstandard even Forced to 1 Switch at field boundary
Nonstandard odd Toggles Switch at field boundary
Standard ITU-R BT 656 ITU-R BT.656
01 = (default)
Nonstandard Toggles Switch at field boundary
Standard ITU-R BT 656 ITU-R BT.656
10 =
Nonstandard Pulsed mode Switch at field boundary
11 = Reserved
(1) F and V control bits are only enabled for F-bit control modes 01 and 10 (see register 69h).
72 Internal Control Registers Copyright © 2005–2011, Texas Instruments Incorporated
Submit Documentation Feedback
focus.ti.com: TVP5160