Datasheet

OUTPUT

CAP - 0.1 Fm

RES - 0 W

Jumper Setup

www.ti.com

Table 5. Input SMA/Jumper Assignment (continued)

Input SMA Jumper

IN4 J4 J20

IN5 J5 J21

IN6 J6 J22

IN7 J7 J23

IN8 J8 J24

2.6 Outputs

The EVM board has eight outputs. The output structure is shown in Figure 7. Each output has an SMA

connector and two jumpers associated with it.

Figure 7. Output Structure

Table 6. Output SMA/Jumper Assignment

Output SMA Jumper Jumper

OUT1 J9 J25 J26

OUT2 J10 J27 J28

OUT3 J11 J29 J30

OUT4 J12 J31 J32

OUT5 J13 J33 J34

OUT6 J14 J35 J36

OUT7 J15 J37 J38

OUT8 J16 J39 J40

3 Jumper Setup

Five jumpers are needed for typical operation. See Figure 2 and Figure 2 for the location on the board..

Jumpers J43, J53, and J54 need to be set up as shown in Figure 8–Figure 10 depending on whether an

external supply is used. Jumpers J52 and J51 bypass the filter inductor and must be installed.

TX810, 8-Channel, Current-Programmable, Low-Noise, Transmit/Receive Switch SLLU141A–March 2011–Revised May 2011

Evaluation Module

Submit Documentation Feedback