User's Manual

6
. Lift the status LCD assembly out of the unit.
7
. Reinstallation of the status LCD assembly is the reverse of Steps 1
through 6.
6.5.8
Removing/Replacing the Top Case Assembly
To remove and replace the top case assembly assembly, perform the
following procedure:
1
. Remove the keyboard assembly as described in Paragraph 6.5.5.
2
. Remove the display assembly as described in Paragraph 6.5.6.
3
. Remove the LCD status assembly as described in Paragraph 6.5.7.
4
. Unplug the small cable located next to the keyboard ZIF connector.
5
. Flip the unit over and remove the eight screws from the base.
Do Not
remove the flat head screw at the rear of the unit next to the switch.
Note
: You do not need to remove the two screws holding the RAM
access door to the base assembly.
6
. Remove the screw to the right of the display cable interface board
(located behind the status LCD assembly).
7
. Turn the unit over and lift the rear of the top case assembly one to
two inches; then pull the top case towards you while keeping the base
in place.
8
. Reinstallation of the top case assembly is the reverse of Steps 1
through 7 above.
6.5.9
Removing/Replacing the Glidepad Assembly
To remove/replace the glidepad assembly, perform the following procedure:
1
. Remove the top case assembly as described in Paragraph 6.5.8.
2
. Flip the top case assembly over and lay it on a flat surface.
3
. Remove the four screws that secure the glidepad board assembly to
the plastics.
4
. Carefully lift the glidepad board out of the plastics. Note that the
glidepad is tethered to the button board by a cable and LIF
connectors.
5
. Replacement of the glidepad assembly is the reverse of Steps 1
through 4 above.
6.5.10
Removing/Replacing the IR/Sound Assembly
To remove and replace the IR/sound assembly, perform the following
procedure:
1
. Remove the top case assembly as described in Paragraph 6.5.8.
6-12
Field Service