User's Manual

Chapter 12: Programming
225
7312ENG.DOC CH 12 Programming, English Julie Hewlett Revised: 07/29/98 12:17 PM Printed: 05/19/99 9:02
AM Page 225 of 32
3. Enter
PROGRAM1
at the
cursor.
-t
P
b
R
b
O
b
G
b
R
b
A
b
M
b
1
Done
b
4. Display the Program editor
with the name of the
program on the top line.
b
The Program EditorThe Program Editor
You use the Program editor to enter and edit program
commands. Enter the Program editor in one of two ways:
• Create and name a new program from the 8
NEW
menu with
1:Create New
. Once the name is entered, the
calculator automatically enters the Program editor with
the name of the program on the top line.
• Select a program to edit from the 8
EDIT
menu
(8 "). The calculator automatically enters the
Program editor with the name of the program on the top
line.
Each new command line in the Program editor begins with a
colon (
:
). Enter programming commands at the cursor. You
can enter more than one command per line. To do this,
separate the two commands with a colon (- |
$ $ $ b). If the command line is longer than the screen
is wide, the command wraps to the next screen line.
To exit the Program editor, press - l. All commands are
automatically saved.
Begin entering the
name at the cursor.