Owner's manual

Thank you for purchasing this Texsport tent. Please read and understand each step of the set-up instructions. We encourage you to set-up this tent

at least once prior to your camping trip, ensuring that you have a satisfactory understanding of the set-up process. We hope you enjoy your new

ent and that it will give you many years of camping pleasure.

Do not apply excessive force to this product.

PARTS LIST:

A - Tent Skin

B - 1 Fiberglass Fly Pole

C - 2 Fiberglass Tent Poles

E - Tent Stakes, Ropes

and Clews

NOTE:

repare your camp site by removing all

sharp stones, twigs, etc. The site should

be flat and have no depressions that

could collect rain water.

STEP 1 - Spread the tent floor on the

ground and assemble tent poles. Lay

poles in an X formation on the tent

skin.

STEP 2 - Insert the tent pole into a

web pocket and do the same for the

opposite end of the tent pole.

STEP 3 - Attach the speed clips to

secure tent poles.

STEP 4 - This is how your tent should

look like at this point.

STEP 5 - Secure the tent poles together

with the ties provided in the center.

STEP 6 - Stake down the tent once you

are sure you have it in the right place.

STEP 7 - Spread fly out on the ground. STEP 8 - Assemble fly pole and insert

into the web pockt on the fly.

STEP 9 - Tie fly pole to secure with

ties.

INSTRUCTIONS

Item 01101

Hayden Square Dome Tent

01101 Instructions 12-10_Layout 1 12/27/10 1:32 PM Page 1

PAGE 1
01101 Instructions 12-10_Layout 1 12/27/10 1:32 PM Page 1 INSTRUCTIONS Item 01101 Hayden Square Dome Tent Thank you for purchasing this Texsport tent. Please read and understand each step of the set-up instructions. We encourage you to set-up this tent at least once prior to your camping trip, ensuring that you have a satisfactory understanding of the set-up process. We hope you enjoy your new tent and that it will give you many years of camping pleasure. Do not apply excessive force to this product.
PAGE 2
STEP 7 - Drap fly over tent and secure with the fly hooks onto the tabs. STEP 8 - This is how your built tent should look. STEP 9 - In high winds, it is recommended to guy rope your shelter. Insert the guy rope as shown above into a clew, and tie a knot. STEP 10 - Tie the other end of the guy rope to the shelter. STEP 11 - Pull out the bottom section looped in the clew. The knot will not allow the rope to slip out. STEP 12 - Loop this around a stake and push into the ground.