User manual

69
he may remove the transmitter so that the data from this channel will not be displayed in the temperature
station. The below procedures describe how to “re-learn” or “remove” a channel:
1. Press and hold the OK key until the digits “Lcd” starts flashing.
2. Press shortly the OK key twelve times to enter Learn/ Remove setting of channels. The digits
“Lrn”, “CH” and the channel icons will be flashing.
3. Press Plus to select Channel 1. The digit ”1” will be flashing.
4. Press Plus to set Channel 1 to “Re-learn” state (The channel icon will be flashing), or press Minus
to remove Channel 1 (The channel icon will disappear).
5. Press OK key to select Channel 2. The digit “2” will be flashing.
6. Repeat the above steps to Channel 2 to 5, setting them either in “re-learnt” or “removed” state.
Note: Once a channel is removed, the temperature station will be “disconnected” form the channel and
the data transmitted by this channel cannot be viewed at the temperature station.
Digit flashing
Flashing