Operation Manual
53
To set the clock:
1. The hour digits start flashing in the time display section.
2. Use the + key to adjust the hours and then press SET key to go to the minute
setting.
3. The minute will be flashing. Press the + key to just the minutes.
4. Confirm with the SET or MIN/MAX RESET key and exit the setting mode.
Note :
The unit will still try to receive the signal despite a manual setting. When the signal is
received, the manually set time will automatically be replaced by the received time.
During reception attempts, the DCF tower icon will flash. If reception has been
unsuccessful, the DCF tower icon will not appear but reception will still be attempted.