Operation Manual

1918
KLIMA-MONITOR - Wireless Thermo-Hygrometer

KLIMA-MONITOR - Wireless Thermo-Hygrometer

B: Buttons (Fig. 1):
B 1: MIN/MAX / – button
B 1: ALARM / SET button
B 1: CHANNEL / + button
C: Housing (Fig. 2):
C 1: Stand (fold out)
C 2: Battery compartment
D: Transmitter (Fig. 3):
Housing front:
D 1: Transmission signal lamp
Display:
D 2: Channel number
D 3: Temperature and humidity
Housing back side:
D 4: Wall mounting hole
D 5: Battery compartment
Inside the battery compartment:
D 6: Switch 1, 2, 3 and 4
6. Getting started
•
Place the instruments on a desk with a distance of approximately 1.5 meter.
Avoid getting close to possible interference sources (electronic devices and
radio installations).
6.1 Installation of the transmitters
1. Open the screwed battery compartment of the first transmitter.
2. Slide down for the first transmitter the first, the second and the third
switch.
3. Slide up the fourth switch to select temperature display in °C (Celsius) or
slide down to select °F (Fahrenheit) as the temperature unit.
4. Insert two new batteries 1,5 V AAA. On the display appear the temperature
and humidity and the channel number 1.
5. Close the battery compartment again.
Caution!
 Risk of injury:
• Keep this instrument and the batteries out of the reach of children.
• Batteries must not be thrown into a fire, short-circuited, taken apart or
recharged. Risk of explosion!
• Batteries contain harmful acids. Low batteries should be changed as soon as
possible to prevent damage caused by leaking. Never use a combination of
old and new batteries together, nor batteries of different types.
• Wear chemical-resistant protective gloves and safety glasses when handling
leaking batteries.
 Important information on product safety!
•
Do not place your product near extreme temperatures, vibrations or shocks.
• Protect it from moisture.
• The transmitter is protected against splash water, but is not watertight.
Choose a shady and dry position for the transmitter, when used outside.
5. Components
Basic station (Receiver)
A: Display (Fig. 1):
Display 1, 2 and 3 for transmitter 1-3
A 1: Channel number with reception and battery symbol
A 2: Temperature
A 3: Temperature tendency indicator
A 4: Hi-/low-alarm for temperature
A 5: Comfort level symbol
A 6: Humidity
A 7: Hi-/Low-Alarm for humidity
A 8: Marking for selected channel
A 9: Symbol for MAX/MIN
Display IN for internal sensor and transmitter 4-8
A 10: Display for internal sensor and transmitter 4-8
TFA_No. 30.3054_Anleitung 27.10.2014 17:04 Uhr Seite 10