Operation Manual

34
To wall mount:
1. Fix a screw (not supplied) into the
desired wall, leaving the head
extended out by about 5mm.
2. Place the weather station onto
the screw, using the hanging hole
on the backside. Gently pull the
weather station down to lock the
screw into place.
Foldout table stand:
The foldout table stand leg is located
on the backside. Pull the stand out
from the bottom center edge of the
weather station, below the battery
compartment. Once the foldout table
stand is extended, place the weather
station in an appropriate location.
POSITIONING THE THERMO-HYGRO
TRANSMITTER
Mounting at a sheltered place. Avoid direct
rain and sunshine.
The thermo-hygro transmitter can be placed
onto any flat surface or wall mount using the
bracket which doubles as a stand or wall
mount base.
To wall mount:
1. Secure the bracket onto a desired wall
using the screws and plastic anchors.
2. Clip the transmitter onto the bracket.
Note:
Before permanently fixing the thermo-hygro to
the wall base, pace all units in the desired
locations to check that the outdoor temperature
and humidity readings are receivable. In event that the
signal is not received, relocate the thermo-hygro
transmitter or the weather station slightly as this may help
the signal reception.