Operation Manual

TIME ZONE SETTING:

The time zone default of the weather station is “0”. To set

a different time zone:

1. The current time zone value starts flashing.

2. Use the + key to set the time zone. The range runs

from 0 to -12 and then runs from +12 back to 0 in

consecutive 1-hour intervals.

3. Confirm with the SET key and enter the Manual

Time Setting.

MANUAL TIME SETTING:

In case the weather station cannot detect the DCF-signal

(for example due to disturbances, transmitting distance,

etc.), the time can be manually set. The clock will then

work as a normal quartz clock.

1. The hour digit will start flashing.

2. Use the + key to set the hour.

3. Press again the SET key to set the minutes. The

minute digits start flashing.

4. Use the + key to set the minutes.

Confirm with the SET key and enter the Calendar

setting.

Note:

The unit will still try and receive the signal despite it being

manually set. When it does receive the signal, it will

change the manually set time into the received time.

During reception attempts the DCF tower icon will flash. If

reception has been unsuccessful, then the DCF tower icon

will not appear but reception will still be attempted the

following day.

Flashing

Hour flashing

Minutes flashing