User Manual

ManualsBrandsTFCFL ManualsSpot Welding EquipmentAutomatic Spot Welder Pulse Argon Arc Welding Machine Jewelry Welder 110V Spot Welder for Jewelry Welding Jewelry Repair Tool 50-600A

4. Welding

Put welding circuit clamp clip in workpiece and grasp the

welding workpiece, looking into the eyepiece and let welding

place touch tungsten electrode tip. Don push too hard for left

space of automatic retraction, and the machine will welding

naturally.

Attention：The two electrodes can never short-circuit

5. Operation Tips

Pressure Hint: The indicator

light below the Select button

of panel will flash, when the

gas pressure of argon can not

reach the welding pressure

demand.(According to current setting)

Waiting for welding：The button

of wait is on means charging and

the light turn to Ready means

charge complete

Ready：Everything is right after

boot and the Ready indicator lit,

you can start welding.

6. Replacement of Lens

There install an cover lens under

electric protective filter because of

it is too close to welding place. And

the lens will bonding welding slag, you

should replace it based on the bonding

extend.

Note

：

The electric protective filter

maybe diminished after two years

using.

Contents

A.Safety Consideration ………………………………1

B.Main Instruments ……………………………………2

C.Operation Panel and Button Manual ……………3

D.Main Performance Parameters ……………………4

E. Application Method ………………………………4

1. Preparation for Instruments ………………4

2. Installation of Tungsten Electrode

Welding ……………………………………………5

3. Instrumentation Settings ……………………5

4. Welding ……………………………………………7

5. Operation Tips …………………………………7

6. Replacement of Lens ……………………………7

Summary of content (4 pages)

PAGE 1
4. Welding Put welding circuit clamp clip in workpiece and grasp the welding workpiece, looking into the eyepiece and let welding place touch tungsten electrode tip. Don push too hard for left space of automatic retraction, and the machine will welding naturally. Attention：The two electrodes can never short-circuit Contents A.Safety Consideration ………………………………1 B.Main Instruments ……………………………………2 5.
PAGE 2
We are very grateful for you choosing the product we manufactured. Our company is specialized in developing, exploiting and manufacturing dental equipment. Through our Unremitting efforts and concentrated research, the Pulse argon arc welding machine we developed owns the same level of the international product, is safe, green and environment protecting equipment. Equipment cost and running cost are far below laser welding machine.
PAGE 3
2.The Installation of Welding Handle and Tungsten Electrode B.Main Instruments The order of installation is as shown. Unplug welding handle cover in real practice and unscrew locking head, inserting tungsten electrode. Using the cover measure the tungsten electrode exposes 10-15mm after installation. Than screw locking head and cover。 1 2 3 The tungsten electrode should keep sharp status, angle LE 25°.
PAGE 4
C.Operation Panel and Button Manual D.Main Performance Parameters Input Voltage&Frequency 110～220V/50Hz Welding Voltage 40V Input Power 100W Welding Current 50A～600A Protective Tube 250V/2.0A Welding Time 3ms～30ms IP Grade IP21 Max Welding Frequency 1Hz Gas Supply Pressure ≥0.1Mpa Max Argon Consumption 5L/min E.Application Method 1.