User's Manual

COMTRAC RADIO
Business Entity Identifier
Business Identifier
DTC
Revision
9950-15900
3CU 04036 0026 PCZZA
108
0A
Template : 83410477-DOC-CAN-EN
34 / 37
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply within the limits for a Class DSS
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which
cases the user will be required to correct the interference at his/her own expense.
FCC Information Statements
Changes or modifications not expressly approved by Thales could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
The intended use of the ComTrac Radio is not for the general public. It is for
industry/commercial use in Thales Communication Based Train Control (CBTC) systems
and cannot be sold retail, to the general public or by mail order.
The ComTrac Radio requires professional installation, as the installed unit requires
special programming (configuration is based on site specific parameters) during system
deployment and access must be limited (secure) due to safety requirements.