Installation Guide
Table Of Contents
- RECORD OF CHANGES
- Thales Defense & Security, Inc.
- Equipment included in this declaration
- Declaration
- Manufacturer
- Place and Date
- CHAPTER 1 INTRODUCTION
- Description
- Indicator
- B/ System
- System functioning properly
- Solid GREEN
- System busy (Booting up)
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- B/ Satellite
- Connected and passing data (over satellite)
- Solid BLUE
- System functioning properly
- Solid GREEN
- Acquiring satellite
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- / Wi-Fi
- Wi-Fi OFF
- OFF
- Wi-Fi busy
- Flashing GREEN
- System functioning properly
- Solid Green
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- CHAPTER 2 INSTALLATION
- Description
- Indicator
- / System
- System functioning properly
- Solid GREEN
- System busy (Booting up)
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- / Satellite
- Connected and passing data (over satellite)
- Solid BLUE
- System functioning properly
- Solid GREEN
- Acquiring satellite
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- / Wi-Fi
- Wi-Fi OFF
- OFF
- Wi-Fi busy
- Flashing GREEN
- System functioning properly
- Solid Green
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- CHAPTER 3 TROUBLESHOOTING
- CHAPTER 4 TECHNICAL SPECIFICATIONS
- CHAPTER 5 ACRONYMS / GLOSSARY
1-5
Installation Guide 84465 Rev. F
The TU back panel (left to right) has a Wi-Fi antenna connector, reset button, SIM Card slot,
GPIO (I/O) connector, 10-32Volt DC input connector, 12Volt DC power input, antenna
connector, and chassis grounding lug.
Figure 1-5 Terminal Unit (TU) Back Panel Detail
Broadband Active Antenna (BAA)
The BAA is a separate unit that connects to the TU through a single coaxial cable. DC power,
RF transmit and receive signals, control data and GPS data are communicated between the BAA
and TU through the single coaxial cable. Connect provided cable to the antenna after installing
the antenna and before connecting it to the TU. The connector is shown in Chapter 2.
Figure 1-6 Broadband Active Antenna (BAA) for Certus 350 and Certus 200 Systems