Installation Guide

2-3
Installation Guide 84465 Rev. F
Installation of the Certus 350 Broadband Active ANTENNA (BAA)
The Standard MissionLINK Certus 350 kit includes these hardware kits whereas as the Base
MissionLINK 350 kit does not include them but can be ordered as accessories. The guidelines
below are based on the use of these kits during installation.
o Magnetic Mounting: Mounting Hardware Kit PN 1100790-501
o Hard Mount: Mounting Hardware Kit PN 1100792-501
It is important to note that the coaxial cable provided in the Standard MissionLINK kit, or one of
the Thales approved accessory coaxial cables, must be installed for proper operation of the
MissionLINK system. Otherwise, the system may not calibrate correctly and will result in a
failure at start-up. Install the cable using best practices for cable bend radius and to avoid
pinching the cable. It is also important to ensure the cable does not get cut by or rub on nearby
sharp objects. If a specific cable length is needed, refer to Table 1-4.