Installation Guide
Table Of Contents
- RECORD OF CHANGES
- Thales Defense & Security, Inc.
- Equipment included in this declaration
- Declaration
- Manufacturer
- Place and Date
- CHAPTER 1 INTRODUCTION
- Description
- Indicator
- B/ System
- System functioning properly
- Solid GREEN
- System busy (Booting up)
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- B/ Satellite
- Connected and passing data (over satellite)
- Solid BLUE
- System functioning properly
- Solid GREEN
- Acquiring satellite
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- / Wi-Fi
- Wi-Fi OFF
- OFF
- Wi-Fi busy
- Flashing GREEN
- System functioning properly
- Solid Green
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- CHAPTER 2 INSTALLATION
- Description
- Indicator
- / System
- System functioning properly
- Solid GREEN
- System busy (Booting up)
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- / Satellite
- Connected and passing data (over satellite)
- Solid BLUE
- System functioning properly
- Solid GREEN
- Acquiring satellite
- Flashing GREEN
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- / Wi-Fi
- Wi-Fi OFF
- OFF
- Wi-Fi busy
- Flashing GREEN
- System functioning properly
- Solid Green
- Fault (minor issue)
- Solid RED
- Critical fault (major issue)
- Flashing RED
- CHAPTER 3 TROUBLESHOOTING
- CHAPTER 4 TECHNICAL SPECIFICATIONS
- CHAPTER 5 ACRONYMS / GLOSSARY
2-6
Installation Guide 84465 Rev. F
1. Assemble Items No. 1 (3x) and 2 (3x) (included with Antenna Mounting Hardware Kit
PN 1100790-501) to antenna at the three perimeter mounting points as shown in Figure
2-2 and hand tighten.
NOTE
Do Not tool tighten or torque the mounts. Doing so could cause
damage to the unit.
2. Place Antenna in desired final operating location on ferrous surface with all three
magnets in contact with surface. Failure to make contact with all three magnets may
cause loss of mount integrity.
3. Connect coaxial cable as shown in Figure 2-2 and hand tighten.
4. After connecting the cable to the antenna (Figure 2-2), wrap the connector with the self-
vulcanizing tape to ensure a water-tight seal.
5. Run coaxial cable, Figure 2-2, to the TU installation location.
NOTE
IMPORTANT: Antenna cable connection should be secured
tightly and covered with protective rubber boot or self-
vulcanizing tape to prevent corrosion and water intrusion.
NOTE
IMPORTANT: When removing the antenna with magnetic
mounts from a metal surface, do not pull up on the coaxial cable
or connector. This could damage the antenna.