User's Manual

4-24
User Manual PN 84468 Rev I
Table 4-7 Settings  LAN
Section
Value
LAN Ports
LAN Port 1
POE OFF / POE ON (POE ON is the default setting)
LAN Port 2
Disable POE OFF / POE ON (POE ON is the default setting)
Disabled / Enabled (Enabled is the default setting)
LAN Port 3
POE OFF / POE ON (POE ON is the default setting)
Disabled / Enabled (Enabled is the default setting)
Static Routes
Static Route
Enter the Name, Subnet IP Address, Subnet Prefix, and Gateway IP
address for the static route
(Note: The Gateway address assigned to the router that connects the
terminal to the network.)
LAN MAC Address
MAC Address
Enter the MAC address (same for all LAN switches)
DHCP
Enable DHCP
Disabled / Enabled (Enabled is the default setting)
IP Address
Enter the IP Address
Mask
Enter the Mask Number
Start
Enter the starting value for the octet
End
Enter the ending value for the octet
Lease Time
Enter the Lease Time being allotted (in seconds)
DHCP Reservations
Name
Enter the name of the DHCP Reservation
Duration
Enter the length of time (in seconds)
MAC
Enter the MAC address
Address
Enter the last digits of the IP Address
Enabled/Disabled
Disabled / Enabled (Enabled is the default setting)
WAN
NOTE
This is an ADMIN function only. If the user sees this icon,
login as the ADMIN to continue. Otherwise this is a view only
screen.
The WAN page, shown in Figure 4-27, allows configuration of the WAN data service. The
settings include configuring whitelists and blacklists for domains, configuring port blocking and
port whitelists.
When adding a Domain to a Blacklist/Whitelist it is always necessary to first select the
button BEFORE selecting the button. After selecting the button, the domain can
always be edited or deleted using the buttons BEFORE selecting the button to