User's Manual

4-26
User Manual PN 84468 Rev I
Table 4-8 Settings  WAN
Section
Value
Configuration
Polling Intervals
Sets the length of polling intervals, 30 is the default setting
Hostname
Lists the Hostname. Certus
™
is the default setting.
WAN Failover Ping
Address
Enter an IP address to change the default network availability ping
from gstatic.com to an IPv4 address
Mode
Select DHCP or Static. (DHCP is the default setting.)
Domain Whitelist & Black List
Domain Blocking
Mode
OFF / Blacklist / Whitelist (OFF is the default setting)
Blacklisting
Enabling allows ALL websites EXCEPT those listed (very little
restriction)
Whitelisting
Enabling blocks ALL websites EXCEPT those listed (the most
restriction)
Port Blocking
Port Blocking
Disabled / Enabled (Disabled is the default setting)
Port Whitelist
Enter the Starting Port and Ending Port number.
Select the applicable protocol (TCP & UDP or TCP only or UDP
only) (TCP & UDP is the default setting)
Phone
NOTE
This is an ADMIN functional only. If the user sees this icon,
login as the ADMIN to continue. Otherwise this is a view only
screen.
The Phone Settings page, shown in Figure 4-28, allows configuration of phone extensions and
mapping of those extensions to the outbound Iridium phone lines as well as which extension
rings for each inbound Iridium line. There are up to three (3) high quality Iridium phone lines.
Each extension can be mapped to one, two, three or none of the Iridium phone lines for outbound
calls by checking the box next to the corresponding Line in the Outbound Lines column. By
selecting the icon, a password can be entered for each extension if desired. An extension
can be deleted by selecting the icon. All changes are saved only after the APPLY button is
selected.
Each of the three Iridium phone lines (Inbound) can be mapped to ring only one extension. The
extension is selected from the pull-down menu. Configuration of analog devices such as the
POTS phones and the Radio Gateway are configured on this page. Each of these devices can be
mapped to an extension.
Finally, in the Phone Configuration area, call logs can be enabled or disabled and the POTS
phone impedance can be selected for optimal performance.