User's Manual

4-28
User Manual PN 84468 Rev I
Table 4-9 Settings  Phone
Section
Value
Dial Plan
Disabled / Enabled
Disabled – when selected, the requirement to dial a “9” before making
a call across Iridium is now disabled. (Note: When disabled, all calls
go across the Iridium constellation and local extension to extension
calls are disabled.) (ENABLED is the default setting)
Extension Mapping
1-88888
Additional custom extensions of varying lengths can be added.
1001
Default extensions that receives and makes calls on the first Iridium
line. Connected to the first POTS line.
1002
Default extensions that receives and makes calls on the second Iridium
line. Connected to the second POTS line.
1003
Default extension that receives and makes calls on the third Iridium
line.
Inbound Iridium Lines
1-88888
Maps each inbound Iridium line to a single extension previously set
up.
1001 - 1003
Default extensions 1001, 1002 and 1003 are mapped to Line 1, Line 2
and Line 3 respectively
Device Mapping
POTS
Assigns extensions to POTS 1 and POTS 2 phones
(Note: 2 POTS phones can be attached with a splitter to the POTS
connector.
Radio GW
Assigns extension to the Radio Gateway
Phone Configuration
Enable Call Log
Disabled / Enabled (Enabled is the default setting). Call logs display
Active Calls and Call History when the Calls menu item is selected.
POTS Impedance
Sets the dynamic output of the POTS system to match regional Phone
types (USA, Australia, Europe, UK, USA-Loaded) (USA is the
default setting)
POTS Compliance
Sets the POTS Compliance to match regional phone types. (USA or
Brazil). (USA is the default setting)
NOTE
Extensions must begin with a number from 1 to 8 and are limited
to four (4) digits.