Installation Guide

2-8
Installation Guide 84464 Rev. E
Figure 2-5: Mounting Holes in Bottom of Antenna and Mounting Template
Mounting using M6 Hardware
1. Use the template information provided in Appendix A to create the appropriate hole
pattern in the desired mounting surface for the chosen mounting hardware.
NOTE
Hole sizing and provided hardware are shown for through hole
mounting as shown in Appendix A. User may mount antenna
with other hardware at their discretion and own risk.
2. Position the pattern to avoid interferences with the antenna or coaxial cable connection to
the antenna.
3. Position the antenna in the proper orientation as decided by the pattern placement for the
chosen mounting pattern on the base of the antenna (Refer to Appendix A).
NOTE
IMPORTANT: The antenna is mounted with four M6 (torque
to 6 Nm (4.5 ft.-lbs.)) stainless steel bolts (included with
Antenna Mounting Hardware Kit PN 1100791-501) as
appropriate for mounting plate thickness of .20 to .40 inches (5
to 10 mm.). Never exceed the recommended torque values on
mounting bolts as this will damage the unit.
NOTE
Apply the supplied anti-seize to the hardware before assembly IF
mounting to metallic plate incompatible with stainless steel
hardware.
4. Connect coaxial cable as shown in Figure 2-6 and hand tighten
5. After connecting the cable to the antenna (Figure 2-6), wrap the connector with the self-
vulcanizing tape to ensure a water-tight seal.