Installation Guide

2-10
Installation Guide 84464 Rev. E
NOTE
Mounting Hardware Installation Kit (PN 1100791-501) may
contain additional hardware spares. The quantity listed in the
above table reflects what is required for installation.
Mounting using M10 Hardware
1. Use the template information provided in Appendix A to create the appropriate hole
pattern in the desired mounting surface for the chosen mounting hardware.
NOTE
Hole sizing and provided hardware are shown for through hole
mounting as shown in Appendix A. User may mount antenna
with other hardware at their discretion and own risk.
2. Position the pattern to avoid interferences with the antenna or coaxial cable connection to
the antenna.
3. Position the antenna in the proper orientation as decided by the pattern placement for the
chosen mounting pattern on the base of the antenna (Refer to Appendix A).
NOTE
IMPORTANT: The antenna is mounted with four M10
(torque to 28 Nm (21 ft.-lbs.)) stainless steel bolts as appropriate
for mounting plate thickness of .20 to .47 inches (5 to 12 mm.).
Never exceed the recommended torque values on mounting
bolts as this will damage the unit.
NOTE
Apply the supplied anti-seize to the hardware before assembly IF
mounting to metallic plate incompatible with stainless steel
hardware.
4. Connect coaxial cable as shown in Figure 2-7 and hand tighten.
5. After connecting the cable to the antenna (Figure 2-7), wrap the connector with the self-
vulcanizing tape to ensure a water-tight seal.
6. Assemble screws (1) with flat washers (3) and split lock washers (2) as shown in Figure
2-7 and torque to requirements.
7. Run coaxial cable to approximate location of the BDU installation location.