Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 GSM/UMTS/LTE Antenna Interface
- 2.3 GNSS Antenna Interface
- 2.4 Sample Application
- 3 GNSS Interface
- 4 Mechanical Dimensions and Mounting
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
ALAS5 Hardware Interface Overview
5.4 Compliance with FCC and ISED Rules and Regulations
42
ALAS5_HIO_v00.030a 2019-04-01
Confidential / Preliminary
Page 40 of 50
5.4 Compliance with FCC and ISED Rules and Regulations
The Equipment Authorization Certification for the Gemalto M2M modules reference application
described in Section 5.3 will be registered under the following identifiers:
•ALAS5-W:
FCC Identifier QIPALAS5-W
Granted to Gemalto M2M GmbH
•ALAS5-AM:
FCC Identifier QIPALAS5-AM
ISED Certification Number: 7830A-ALAS5AM
Granted to Gemalto M2M GmbH
Note
1
: Manufacturers of mobile or fixed devices incorporating ALAS5-W/-AM modules are au-
thorized to use the FCC Grants and ISED Certificates of the ALAS5-W modules for their own
final products according to the conditions referenced in these documents. In this case, the FCC
label of the module shall be visible from the outside, or the host device shall bear a second label
stating "Contains FCC ID: QIPALAS5-W"or "Contains FCC ID: QIPALAS5-AM", and accord-
ingly “Contains IC: 7830A-ALAS5AM“. The integration is limited to fixed or mobile categorized
host devices, where a separation distance between the antenna and any person of min. 20cm
can be assured during normal operating conditions.
For mobile and fixed operation configurations the antenna gain, including cable loss, must not
exceed the limits listed in the following Table 11 and Table 12 for FCC and/or ISED.
1. Label note in French for ISED: Les fabricants d'équipement mobile ou fixe intégrant le module
ALAS66A-W/-US sont autorisés à utiliser les accords FCC et certificats d'Innovation, Sciences et Déve-
loppement économique Canada (ISED) du module ALAS5-W/-AM pour leur propre produit final suivant
les conditions référencées dans ces documents. Dans ce cas, le label FCC du module doit être visible
de l'extérieur, sinon l'équipement hôte doit disposer d'un second label avec la déclaration suivante "
Contains FCC ID : QIPALALAS5-W ", ou " Contains FCC ID : QIPALALAS5-AM " et en conséquence "
Contains IC : 7830A-ALAS5AM ". L'intégration est limitée aux catégories d'équipement hôte mobile ou
fixe, respectant une distance minimum de 20 centimètres entre l'antenne et toute personne avoisinante
pour des conditions d'utilisation normale.
Table 11: Antenna gain limits for FCC for ALAS5-W (TBD.)
Maximum gain in operating band FCC limit Unit
850MHz (GSM) dBi
1900MHZ (GSM) dBi
Band V (UMTS) dBi
Band 5 (LTE-FDD) dBi
Band 7 (LTE-FDD) dBi
Band 26 (LTE-FDD) dBi