Product Card
Table Of Contents
- Contents
- Tables
- Figures
- 0 Document History
- 1 Introduction
- 2 Product Concept
- 3 Application Connector Interface
- 3.1 Pin Assignments and Electrical Description
- 3.2 Characteristics
- 3.2.1 Power Supply and Ground
- 3.2.2 Control Signals
- 3.2.3 Tunable Antenna Interface
- 3.2.4 WWAN/WiFi Coexistence Control
- 3.2.5 Dynamic Power Reduction
- 3.2.6 USB Interface
- 3.2.7 PCI Express® Interface
- 3.2.8 SIM/UICC Interface
- 3.2.9 eUICC Interface
- 3.2.10 GPIO Interface
- 3.2.11 Status
- 3.2.12 Add-in Card Configuration Pins
- 4 Antenna Interface
- 5 Operation
- 6 Appendix
Cinterion
®
MV31-W Hardware Interface Description
5.5 Timing Sequence Requirement
75
t MV31-W_HID_v01.009a 2022-04-27
Public / Preliminary
Page 56 of 76
5.5.2 Power Off Timing Requirement
• The platform should follow the requirement when the device power is Off by M.2 PIN#6 and
when Windows enters S4 and S5.
• Device Power Off by M.2 PIN#6 (Full_Card_Power_Off):
- For Windows10: Platform performs M.2 PIN#6 power off after sending CID_M-
BIM_MSHOSTSHUTDOWN to MV31-W and receiving CID_MBIM_MSHOSTSHUT-
DOWN MBIM_COMMAND_DONE from MV31-W
Figure 28: Device power off behavior for Windows 10
PC MV31‐W
If in online mode,
put to LPM
system(“sync;sync;sync”);
If in online mode,
put to LPM
CID_MBIM_MSHOSTSHUTDOWN (set)
M.2 PIN#6
MBIM_COMMAND_MSG
CID_MBIM_MSHOSTSHUTDOWN
MBIM_COMMAND_DONE
Full_Card_Power_Off
system(“sync;sync;sync”);
system(“sys_shutdown”);
The Mobile Broadband Class Driver sends the
host shutdown notification
(CID_MBIM_MSHOSTSHUTDOWN) to mobile
broadband devices supporting this device
service, on each host state transition into S4
and S5 statuses