User Manual Part 1

IS-900 User Guide Page 36 of 159
3.2. Hardware Set-up
General Equipment Handling Warnings
The ultrasonic transmitters (SoniDiscs) are sensitive electronic
components. Take care not to allow any dirt or moisture in or around the
SoniDiscs install the SoniStrips, SoniFrame, SoniWing or SoniPods.
Mishandling can damage both the ultrasonic receiver microphones and the
embedded InertiaCube in each tracked station.
Do not drop the tracked stations. While InterSense has designed the
devices for normal usage in simulators and virtual environments,
excessive shock can damage the internal components.
Always turn off the IS-900 Processor (remembering to save any
configuration changes) before plugging or unplugging the tracked
stations. Failure to do this could result in damage to the stations.
Always store the tracked devices in a secure location when not in use.
Leaving them on the floor or on an unsecured surface can result in
accidental damage.
This section covers a typical installation of the IS-900 with standard components. Consult
InterSense for non-standard or OEM installations.
The basic steps covered in this section include:
• Installation of SoniStrips
• Mount and Calibration of SoniStrips
• Connection and Test with the IS-900 Processor.
• Special Instructions for Wireless Devices
Unpack all components and check against packing list (standard configuration referenced in
Section 1.2 for the IS-900 SimTracker and 1.3 for the IS-900 VETracker). Check the packing list
that came with the system as many orders will not match the standard configurations shown in
Section 1. Contact InterSense if any components are missing or appear damaged.