User Manual Part 1

IS-900 User Guide Page 47 of 159
• Measurement ranges greater than 3 meters or,
• SoniStrip Arrays configured with greater than 12 SoniStrips where an additional power
booster is required after every 12th SoniStrip in a large SoniStrip Constellation Array.
Figure 21 - External Power Booster for SoniStrips
2. Setup your PC and launch ISDEMO
Follow the directions in Section 14 to install and run ISDEMO on a PC.
3. Connect the communications to the IS-900 system
Choose a communication option for connecting to the PC running ISDEMO. Section 14.3 details
the communication options for connecting with either serial or Ethernet.
3.6. Wireless MicroTrax Setup
Skip this step if you are using wired tracking devices.
IMPORTANT NOTE: Additional wireless IS-900 tracking systems in the immediate area should
be shut down while a new system is being configured to avoid the possibility of interference
during setup.
If you are using wireless devices, we recommend fully charging the Radio/Battery Modules prior
to use. If the power LED on the wireless Wand or Head tracker transmitter is flashing, that is an
indication of a low battery. Once the wireless receiver / transmitter combinations have been
configured below, each receiver will be matched to exactly one transmitter via an “RF Channel”
and “Link ID”. The system will not need to be configured again unless the user wishes to change
which receiver matches with which transmitter.
1. Make sure the IS-900 Processor is powered off.