User Manual Part 1

IS-900 User Guide Page 49 of 159
4. Run ISDEMO and connect to the processor via the “IS-900” configuration. Click
“Parameters->Wireless Configuration” from the menu. You will be presented with the
following dialog:
Port Port of the IS-900 Processor.
Configured Channel The channel that the connected receiver is configured to. No two
receivers can be configured to the same channel.
Reported Channel The channel that the connected receiver is currently on.
Configured Link ID The link ID that assigned to the receiver. Each wireless tracker has a
link ID associated with it when it is shipped. This 5 digit number can be
found on a label on your device.
Reported Link ID The link ID that is currently associated to the receiver.
Status Port status. Any ports with a status of “no receiver” do not have
receivers and cannot be configured
Steps 5-7 should be repeated for every receiver / transmitter combination in the system.
5. Click a row that corresponds with a receiver and click the “Edit” button. The following dialog
will be presented: