User Manual Part 1

IS-900 User Guide Page 6 of 159
While charging the battery
Follow the rules listed below while charging the battery. Failure to do so may
cause the battery to become hot, explode, or ignite and cause serious injury.
• When charging the battery only InterSense’s charging station (ISC-
900MW-CRA*) or individual device charger (099-00076-0000)
Note: * means that the suffix is U, E or K depending on voltage requirements
of your country.
• Do not place the batteries in or near fire, or into direct sunlight. When the
battery becomes hot, the built in safety equipment is activated, preventing
the battery from charging further. Over-heating the battery can destroy the
safety equipment and can cause additional heating, breaking or ignition of
the battery.
Do not continue charging the battery if it does not recharge within the specified
charging time. Doing so may cause the battery to become hot, explode or
ignite.
The temperature range over which the battery can be charged is 0 degrees
Celsius to 45 degrees Celsius. Charging the battery at temperatures outside
of this range may cause the battery to become hot or to break. Charging the
battery outside this temperature range may also harm the performance of the
battery or reduce the battery’s life expectancy.
When discharging the battery
Do not discharge the battery using any devices except for the specified device.
When the battery is used in devices aside from the specified device, it may
damage the performance of the battery or reduce its life expectancy, and if the
device causes an abnormal current to flow, it may cause the battery to become
hot, explode or ignite and cause serious injury.
The temperature range over which the battery can be discharged is –20
degrees Celsius to 60 degrees Celsius. Use of the battery outside of this
temperature range may damage the performance of the battery or may reduce
its life expectancy.
General Warnings & Precautionary Statements
Do not drop or otherwise shock the tracking devices for they can be
permanently damaged.
Do not plug in any devices while the electrical power is applied.
Any changes or modifications to the IS-900 not expressly approved by
InterSense will void the warranty and any regulatory compliance issued for the
system.