User Manual Part 2

IS-900 User Guide Page 91 of 159
9.3. Example of LCD Menu Navigation
As example of a typical use for the LCD panel, here are the steps to find out the current firmware
revision running on the IS-900. Refer to the menu flow chart in the next sectioin to follow the
navigation steps outlined here.
Step 1 – Change to Display mode
When the system is running with one tracker attached
at Port 1, the LCD is in display mode as shown in
Figure 35. The first step is to press the Enter key
which brings the LCD into the top menu of Menu
mode.
Step 2 – Scroll down to System Config
Use the down arrow keys to scroll to the system
configuration menu item.
Step 3 – Access the System Config submenu
Use the ENTER key to access the system
configuration submenu.
Step 4 – Access the Information submenu
Press enter to access the information submenu which
displays the current Firmware Revision of the IS-900.
If left alone, the LCD panel will automatically switch back to Display mode or pressing F1 will exit
the Menu mode directly. Pressing F2 will go up a single level in the menu tree.