User Manual Part 2

IS-900 User Guide Page 97 of 159
unit on the station port the last time the
system was used
in ISDEMO to set up radios (if using
normal mode)
Interference from a transmitter being
used with another IS-900 system
Check for transmitter in the area that
is powered on and set to the same
channel.
Channels for
stations n and m
are both set to x
Receivers are set to the same channel In ISDEMO, select
Parameters?Wireless Configuration
to set up radios
Link ID for stations
n and m are both x
MicroTrax units are not compatible
with each other
Contact InterSense
ISSUE: The Base Receiver Module Connection LED intermittently turns on and off
while using the system.
⇒ Try moving the Base Receiver Module to a different location, either further away from
other Base Receiver Modules or away from any large metal structures and/or closer
to the tracking area.
ISSUE: The Transmitter Module does not last more than 6 hours on a single
charge.
⇒ Make sure the charge light is off before you start to use the device to get the full
charge time.
If the device is over a year old and you have been using it regularly, it may be time to
replace the battery. Contact InterSense on how to return the device for the battery
replacement.
If the device is fully charged but only lasts a short time (less than 5 hours) there may be
a hardware failure. Contact InterSense on how to return the device for service. If you
suspect a hardware failure, do not continue to use the device - it could damage the
battery and cause a danger. See Battery Warnings at the beginning of this manual.