User Manual Part 2

IS-900 User Guide Page 103 of 159
14.2. File Options
The File menu (shown above) provides you with the following options:
Select Hardware Device System Initialization window (also seen at initial start-up) is
shown when Select Hardware Device is selected. Use this
window to select or detect the tracker model connected to your
computer.
Configuration Lock Configuration lock commands are used to prevent
unintentional changes to tracker configurations being saved to
permanent memory. They disable of enable the ^K command
and the W command.
Save Current Settings Sends ^K command to the tracker. This saves the current
settings to nonvolatile memory in the tracker base unit. The
next time the tracker is turned on these settings will be
restored.
Load Power Up Settings Sends ^Y commands to the tracker. This restores the
firmware to the power up condition. All changes made to the
settings since power up or last ^K command are lost.
Load and Save Factory Settings
Sends W command to the tracker. This restores the system
settings to the factory defaults.
Exit Closes ISDEMO