User Manual Part 2

IS-900 User Guide Page 105 of 159
Ethernet Configuration
Ethernet is supported with IS-900 firmware version 4.20 and higher. Ethernet is disabled
by default. An IP address must be configured using the serial port to enable the
Ethernet option. Refer to Section 4.2 to set an IP address for your IS-900 tracker. Two
Ethernet interface paths are available - a command interface and a UDP broadcast
interface. TCP is used in this case with socket port 5005. Only a single client at a time
can connect via the command interface.
Server IP Address Enter the IP address of the IS-900 in the Server IP Address
box, and leave the Network Port set at 5005. After typing the
Server IP Address, you must hit enter while the cursor is still in
the box, or the program will ignore the change.
Network Port This setting must be 5005 for TCP.
Serial Configuration
Default settings are for the serial port set to COM 1 with a baud rate of 115,200.
Serial Port Choose the RS232 port the tracker is connected to.
Baud Rate Choose the communications speed the tracker is connected
at.
Connect ISDEMO attempts to connect to the IS-900 Processor using
the selected communication parameters.
Cancel Exits the screen saving the current selected communication
parameters.