User's Manual

InterSense Doc. No. 072-00105-0I07 Rev. 4.2
IS-900 User Guide Page 105 of 177
Select IS-900 Series interface and click Accept to begin. Use the Detect option from this
first screen to detect serial communication port and baud rate parameters only if you
have trouble setting them manually.
The DLL Compatible interface can be used for all InterSense trackers when isense.dll is
installed in the \WINDOWS\SYSTEM32 directory of a Windows PC. For set-up and
configuration of the IS-900, it is recommended to use the IS-900 Series interface, as
some of the interactive controls through the isense.dll interface are inactive in ISDEMO.
However, the DLL Compatible option can be useful to test that the IS-900 system is
properly interfacing to the isense.dll for verification of an end-user application.
Note: You must select either IS-900 or DLL Compatible (if the isense.dll is installed), or
ISDEMO will not be able to correctly configure your tracker.
If you have an InterSense RF analyzer accessory, you can launch the user interface
from this first screen by selecting Wireless→RF Scope on the menu bar. See section
10.8 for details.
ISDEMO: Main window
This top of the main window is used to display tracking status information for all stations.
G = Genlock indicator. It appears in the right lower corner of the display if GENLOCK
feature is on and working properly. If the “G” is replaced with an “X”, this indicates the