User's Manual
Table Of Contents
- Table of Contents
- Table of Figures
- 1. System Description
- 1.1. IS-900 Configuration
- 1.2. IS-900 SimTracker & VETracker Processor
- 1.3. SoniStrips, SoniFrame, SoniWing & SoniPod acoustic pulse transmitters
- 1.4. Acoustic Constellation Mounting Considerations
- 1.5. Tracking Station Description
- 1.6. IS-900 Cables, Connectors, Adaptors, Power Boosters and Wireless Radios
- 1.7. IS-900 Support CD
- 2. Specifications
- 3. Installation and Set-up
- 4. Interface Communication Protocol
- 5. LCD Status & Settings Screen
- 6. Appendix A – Frequently Asked Questions
- 7. Appendix B – Troubleshooting & Tips
- 8. Appendix C – Health & Safety Warnings with Tracker Use Guidelines
- 9. Appendix D – Care & Maintenance
- 10. Appendix E – ISDEMO Reference
- 11. Appendix F – GENLOCK Synchronization
- 12. Appendix G – Developers Instructions
- 13. Appendix H – Interface Protocol Commands – Quick Reference
InterSense Doc. No. 072-00105-0I07 Rev. 4.2
IS-900 User Guide Page 111 of 177
Ethernet Configuration
Ethernet is supported with IS-900 firmware version 4.20 and higher. Ethernet is disabled
by default. An IP address must be configured using the serial port or LCD menu to
enable Ethernet communication. Refer to Section 4.2 to set an IP address for your IS-
900 tracker. Two Ethernet interface paths are available - a command interface (single
client, bi-directional) and a UDP broadcast interface (multiple clients, receive only). The
TCP port defaults to 5005, but is configurable.
Ethernet Modes Off – Ethernet interface is disabled
Manual - IP address and Subnet Mask are configured
manually, DHCP is disabled. If no IP address is configured
Ethernet is disabled until one is set.
DHCP - IP address and subnet mask are automatically obtained
from a DHCP server.
Server IP Address Enter the IP address of the IS-900 in the Server IP Address
box, and leave the Network Port set at 5005.